The main disadvantages of pipe lining are that it only works on a pipe that still holds its shape, it cannot correct a sag or a badly offset joint, and it narrows the bore slightly. It also needs thorough cleaning, careful reopening of branch connections, and a crew that gets the resin and cure right.
Most limits come from one fact: a liner cures to the shape of the pipe around it. A fully collapsed section gives it nothing to form against, a belly stays a belly, and a badly offset joint leaves a gap the liner cannot bridge. Those spots need digging or pipe bursting, which is why not every sewer pipe can be lined. The liner also adds a thin wall, so the inside diameter shrinks a little, though the smoother wall usually offsets that.
The work around the liner matters as much as the liner. Roots, grease and scale have to come off before it goes in, and a NASSCO overview of lateral lining lists inspection and cleaning first. Where the liner passes a branch line, that opening has to be cut back from inside after curing. A rough or partial cut catches waste and can start a new clog. Resin that does not fully cure, or a liner that wrinkles, weakens the result, so a second camera run checks the finished pipe.
Cost is the other honest drawback. Lining usually pays off by sparing a driveway or yard, but for one short break under open lawn, a small dig or a point repair can cost less than lining the whole run. None of this can be judged without seeing the pipe. A sewer camera inspection shows the shape, the joints and the branch connections, and that footage decides whether lining fits.